Wall Mounted Controllers
LTM build a range of controllers in wall mounted enclosures. They have a wide range of uses for permanent installations.
We start with a wall mounted enclosure, we build the electrical components onto the rear chassis enclosure plate. Outlets to hoists are normally hard wired onto DIN rail terminals situated at the base of the unit. Input power is normally hard wired, however we can provide a short extension cable with CEE connector if required.
The opening door of the controller has a green power LED, lockable E-Stop and a door isolator. The door has a connector for the handset cable to plug into. Controllers for both Direct Control and Low Voltage Controlled hoists are available for 400V, 3 Ph, 50Hz power supply as are single phase units for 220V, 1Ph, 50Hz. The unit is CE certified.
LED directional indicators on the handset.
Supplied with a remote hand set with run button and lockable E-Stop, toggle switches are provided for each hoist with up, neutral and down. 15 metres of cable is supplied between the handset and the plug in point on the controller.
Aluminium stage boxes are available so that a plug in point for the controller can be provided at stage level where perhaps the controller is mounted at higher level